Serial Enabled 16x2 LCD is the nearest evolution of our serial LCD. Included on a single board is a 16x2 LCD and an embedded circuit based around a PIC 16F88. The on-board PIC takes a TTL serial input and prints the characters it receives onto the LCD. The installed firmware also allows for a number of special commands so you can clear the screen, adjust the backlight brightness, turn the display on/off, and more. Communication with SerLCD requires 5V TTL serial at a default baud rate of 9600bps (8-N-1). You can regulate the baud to any standard rate between 2400 and 38400bps. The power (VDD), ground (GND) and RX pins are all broken out to both a 0.1" pitch header as well as a 3-pin JST connector.
1.PCB: 103x36mm 2.LCD: 71.4x26.4mm 3.Embedded PIC 16F88 utilizes onboard UART for greater communication accuracy 4.Adjustable baud rates of 2400, 4800, 9600 (default), 14400, 19200 and 38400 5.Operational Backspace 6.Greater processing speed at 10MHz 7.Incoming buffer stores up to 80 characters 8.Backlight transistor can handle up to 1A 9.Pulse width modulation of backlight allows direct control of backlight brightness and current consumption 10.All surface mount design allows a backpack that is half the size of the original 11.Faster boot-up time 12.Boot-up display can be turned on/off via firmware 13.User definable splash screen